Announcement

Any registration request that is not verified within 2 hours or your registration email bounces, will be deleted.

#1 2020-11-17 08:03:36

admin
Administrator
Registered: 2020-10-27
Posts: 7

Adhesion issues

If you are having adhesion issues, make sure that Eco mode in your printer is turned OFF.  Eco mode is a latent defect in the creality firmware...Some tree hugging idiot at creality once thought that this was a good idea...  Letting your bed cool down while printing is asking for a fail.

Ender 5 and CR series will see this when printing from an SD

Offline

Board footer

Powered by FluxBB